
14
|
Wolf Customer Care 800.222.7820
Side Burner Installation
For natural gas installations, the gas line connection must
be made before installing the side burner.
INSTALL SIDE BURNER
1
Place the side burner into the shroud as shown in the
illustration below. Guide the flexible gas line and wire
harness into the cart access hole. Verify alignment of the
unit prior to securing the side burner to the shroud. If
the side burner does not align properly, remove, loosen
screws, and check the shroud alignment with the tool.
Reposition the side burner until properly aligned.
2
Place a bar clamp with protected ends
behind bullnose
on the fire box and under the shroud. Do not include
any part of bullnose within the bar clamp. Refer to the
illustration below.
3
Compress the bar clamp until the hole in the bullnose
aligns with the threaded hole in the shroud. The align-
ment and placement of this screw is very important to
the side burner alignment. Refer to the illustration below.
4
Attach the side burner to the shroud by first placing the
provided 8-32 hex cap screw into the right side of the
front underside of the bullnose and into the shroud. Then
place the left side hex cap screw. Tighten the screws
and remove the bar clamp.
5
At the rear of the unit, push the side burner toward the
grill to establish the proper gap at the rear. Loosen the
rear cart screws and shift the grill if necessary to achieve
the proper gap. Install the two provided 8-18 pan head
screws through the shroud and into the rear of the side
burner as shown in the illustration below. Verify proper
alignment.
INSTALLATION
ACCESS HOLE
Position side burner
Position bar clamp
HOLES
ALIGN
REAR
SCREWS
Hole alignment
Secure side burner