
wolfappliance.com
|
13
Side Burner Installation
INSTALL SIDE BURNER SHROUD
1
The side burner is placed inside the shroud for shipping.
Lift out to remove.
2
Hang the shroud by hand-starting the four provided
10-32 machine screws through the upper slots of the
shroud into the upper holes of the cart. Do not fully
tighten the screws until the shroud is properly aligned.
Refer to the illustration below.
3
Place the provided alignment tool with the lip placed in
the gap between the grill and the shroud as shown in the
illustration below.
4
To align the front of the shroud, push the alignment tool
back until the center block of the tool is flush against the
front vertical flange of the shroud.
5
Align the front of the shroud (up and down) with the
alignment tool until the top of the tool is flush with the
top surface of the grill bullnose. Align the shroud (front to
back) with the tool until the front of the tool is flush with
the front of the bullnose. Tighten the upper screw. Refer
to the illustration below.
SCREWS
SCREWS
ALIGNMENT
TOOL
SURFACES
FLUSH
UPPER
SCREW
Hang shroud
Align front of shroud
6
To align the back of the shroud, place the alignment tool
at the rear of the shroud. Align the rear of the shroud (up
and down) with the tool until the top of the tool is flush
with the top surface of the grill. Tighten the upper screw.
Refer to the illustration below. With the alignment tool,
verify the front of the shroud did not move, realign if
necessary.
7
Remove the alignment tool and tighten the two
remaining screws to the slots just below the upper
screws.
8
Install the two provided
5
/
16
x
3
/
8
hex drive shoulder
screws into the lower holes of the shroud and through
the cart. Place the two
1
/
4
–20 hex nuts from inside the
cart and tighten. Refer to the illustration below.
ALIGNMENT
TOOL
SURFACES
FLUSH
UPPER
SCREW
SHOULDER
SCREWS
HEX NUT
(INSIDE CART)
Align back of shroud
Secure shroud
INSTALLATION