
wolfappliance.com
|
11
Installation
PREPARATION
Remove and recycle packing materials. Remove labels and
the protective plastic film from the grill.
Place the briquette trays in the grill above the burners with
the flash tubes positioned at the front. Refer to the illus-
tration below. Place the burner grates directly above the
briquette trays with the square openings in the grates at the
front.
POWER TRANSFORMER
For a built-in installation, secure the transformer box in a dry
location, away from the grill firebox and excessive heat area,
but within 2'
(.6 m)
of the right rear opening. Do not install
the transformer box inside the insulating liner.
For a cart installation, mount the transformer box by the two
screws located at the bottom right rear corner of the grill
cart, behind the pull-out shelf. Use the same transformer for
the side burner if installed.
FLASH TUBE
Flash tube position
CART INSTALLATION
1
T
wo mounting screws are provided at the bottom right
rear corner of the cart for the power transformer. Install
the transformer box.
2
Remove the front mounting screws from the cart. Place
the grill onto the cart, allowing enough space at the back
to make the connection to the transformer.
3
Make the connections from the wiring harness located at
the right rear of the grill to the transformer, then slide the
grill back until it is fully engaged with the cart.
4
Secure the grill to the cart with the four screws provided.
Mounting holes in the upper back corners of the grill will
align with the holes in the cart. Secure with two screws.
Remove the drip tray. Install two screws through the side
mounting holes below the grill front panel and into the
cart.
INSTALLATION