Downdraft Installation
13
wolfappliance.com/specs
LEFT OR RIGHT SIDE DISCHARGE
Substituting down discharge with left or right discharge
will switch the blower discharge from the down position to
the left or right of downdraft assembly.
Follow these steps if it is necessary to rotate the blower to
the left or right discharge location. Refer to the illustration
below.
•
Place the downdraft assembly on its back on a flat
work surface.
•
Remove the 4 nuts and 2 clamp channels.
•
Carefully lift the blower and disconnect the motor plug
if necessary. Reposition the blower for left or right side
discharge and reconnect the motor plug.
•
Use the supplied cover plate to close any open space.
•
Replace the clamp channels and use the nuts to
secure the blower in the new position.
•
Use sheet metal screws through the bottom flange to
secure the bottom of the blower.
CLAMP
CHANNEL
NUT
BLOWER
COVER
PLATE
MOTOR
PLUG
SCREW
Left or right side discharge.
Blower Discharge Adjustment
DOWN DISCHARGE ADJUSTMENT
Adjusting the down discharge left or right will keep the
blower discharge in the down position but allows some
side-to-side adjustment.
Follow these steps if the position of the blower discharge
needs to be moved left or right so that ductwork does not
interfere with floor joists, plumbing or wiring below the
downdraft assembly. Refer to the illustration below.
•
Place the downdraft assembly on its back on a flat
work surface.
•
Loosen the 4 nuts and 2 clamp channels.
•
Slide the blower to the desired position.
•
Use the supplied cover plate to close any open space.
•
Tighten nuts to secure the top of blower and use sheet
metal screws through the bottom flange to secure the
bottom of the blower.
CLAMP
CHANNEL
BLOWER
SCREW
NUTS
COVER
PLATE
BOTTOM
FLANGE
Down discharge adjustment.
