18
W O L F
G A S R A N G E S
R E M OV I N G
T H E R A N G E
If removing the gas range is necessary for
cleaning or service, shut off the gas supply.
Disconnect the gas supply and electrical
connections to the unit, then remove the
range. Reinstall in the reverse order and be
sure to check the gas connection for leaks.
Refer the Wolf Gas Ranges Use & Care
Information included with the range for
cleaning recommendations.
Be sure to disconnect the gas supply and
electrical connections before removing
the range.
V E R I F Y
R A N G E O P E R A T I O N
S U R F A C E B U R N E R S
IMPORTANT NOTE: Prior to operating the
range, be sure to read the entire Wolf Gas
Ranges Use & Care Information included with
the range for important safety, service and
warranty information.
The surface burners use electronic igniters in
place of standing pilots. When the burner
control knob is pushed in and turned to the
HIGH position, the system creates a spark to
light the burner. This sparking continues until
the electronic ignition senses a flame.
Be sure to place the burner parts on each
burner base and install the burner grates
before lighting.
To check operation of the surface burners,
push in and turn each control knob to the HIGH
position. The flame should light within four
seconds.
IMPORTANT NOTE: Initial lighting of the
surface burners may take slightly longer, as air
in the system must be purged before gas can
be supplied to the burner.
If the burners do not light properly, turn
control knob to the OFF position. Check that
the burner parts are in the proper position.
Check that the power supply cord is plugged in
and that the circuit breaker or house fuse has
not blown. Check that the shut-off valve is in
the ON position. Check operation again,
waiting at least five minutes; if the burners do
not light properly at this point, contact a Wolf
authorized service center.
O V E N O P E R A T I O N
Turn the oven(s) on and verify that the oven(s)
are coming up to temperature.
IMPORTANT NOTE: A small amount of
smoke and odor may be noticed during the
initial break-in period. Refer to the Gas
Ranges Use & Care Information for additional
information.
