11
Dimensions in parentheses are in
millimeters unless otherwise specified.
U N PA C K
T H E R A N G E
Remove and discard all packing materials,
including cardboard and tape on the outside of
the range and inside the oven cavity.
IMPORTANT NOTE: Do not discard the anti-tip
bracket packed with the range.
A N T I - T I P
B R A C K E T
The rear channel brace is preinstalled at the
factory. Mount the anti-tip bracket at 6
1
/
2
" (165)
minimum from floor. If the range legs are
adjusted higher than the 3" (76) minimum, the
anti-tip bracket must be raised accordingly.
Push the range back until it is flush with the
wall to engage the anti-tip bracket. The
maximum gap between the anti-tip bracket
and the rear channel brace should not exceed
1
/
4
" (6). Refer to the illustration below.
I N S TA L L AT I O N
I N S T R U C T I O N S
WALL
FLOOR
6
1
/
2
"
(165 mm)
MIN TO
FLOOR
SIDE PANEL
ANTI-TIP BRACKET
REAR CHANNEL
BRACE
Anti-tip bracket installation
This range can tip. Injury to persons
could result. Install the anti-tip bracket
packed with the range. Follow these
installation instructions.
M OV I N G
T H E R A N G E
IMPORTANT NOTE: Before moving the range,
protect any finished flooring with appropriate
materials to avoid damage to the floor.
Due to the weight, a dolly with soft wheels
should be used to move your Wolf gas range.
The weight must be supported uniformly
across the bottom.
Move the range by dolly close to its installa-
tion location. The range can be tipped back
and supported on the rear casters while the
dolly is carefully removed. Be sure to protect
the flooring underneath the casters.
Gas and electrical connections should be made
and the backsplash and/or riser installed
before the range is placed in its final position.
Do not lift the range by the oven door
handle(s). This will damage the oven door
and hinges.
