Wolf Garten UL 33 E, Инструкция по эксплуатации

Страница: 8 / 46

Please check noise abatement regulations prevailing in your Country.
Operating Times
Assembly
Assembling bottom handle part (fig. M1)
Insert securing screw (A) from inside through the left side element, so that both projections catch in the recesses (1). Position
insulation element (B) from outside; the two nubs must catch in the holes of the side element (2). Position handle element (M) in
the insulating element (B). Place insulating element (C) so that the large opening points to the outside. Then press washer (D) into
the opening of the insulating element (C) and tighten wing nut (G).
Assemble the right handle element in the same order.
Assembling top of handle (fig. M2)
Attach upper handle element (N) on the lower handle elements (M), making sure that the holes (1) match. Then insert the
connecting screws from outside, put on the washers (F) and tighten the wing nuts (G).
Attaching switch, strain relief and clips (fig. M3)
Fold up switch bracket (1) and position switch (H) on the upper handle element so that the two nubs catch in the holes (2). Close
switch bracket (1) and insert cable strain relief (I). Then fasten switch (H) and cable strain relief (I) with the two screws (K). Fasten
switch cable (3) with the clips (L) on the handle rod.
Attaching protective flap (fig. M4)
Place protective flap (O) on the cover (1). Then press retainer slots (2) into the fastening flaps (3) on the cover (1).
Operation
General
Before using the machine, the lawn must be mowed to a height of about 2.5-3.5 cm. Remove the cut grass from the lawn. The lawn
should be aerated several times each year. The loosened material can be removed with a rake or catch bag* . Afterwards, the lawn
should be fertilized.
* Accessories at additional cost.
Insert connection cable in the strain relief (fig. B2)
Insert coupling of connection cable (3) in the socket of the switch (H). Then guide the cable (4) from outside in a slight loop over the
peg (5) of the strain relief assembly (I).
Connection to the power outlet
(230 Volt AC, 50 Hz). The machine can be connected to any power outlet that is protected by a 10 amp fuse (or line protecting
switch type K - formerly H).
Note:
Use a residual current protection device with a residual current of no more than 30 mA.
Motor on (fig. B2)
Press button (1) and hold.
Lift lever (2) and release button (1).
Motor off (fig. B2)
Release lever (2).
Attaching catch bag* (fig. B3)
Lift protective flap (O). Hang catch bag (1) with the hooks on both bolts** of the side elements.
( * TK 33, accessory at additional cost, ** bolts included with catch bag)
height
(mm)
Moss
Weeds
Grass-
remnants
- 3 X ---
4 X ---
8 --- X
Recommended working depths
Setting the working depth (Fig. B1)
The working depth is adjustable to 3 heights. Pull adjustment arm (1) away from
side cover and allow to catch in desired position (2). Adjust the height alternately
left and right by only 1 position. The adjustment arms must always be in the same
height position.
Lower and middle position of aerator cylinder:
Removes moss and weeds from the lawn.
Top position of aerator cylinder:
Removes grass remnants from the lawn.
8