14
15
Operation
Operating times
Please check noise abatement regulations prevailing in your
country.
Oil Fill
K
Before starting the lawnmower, check the engine oil level.
Before starting the mower, add 0.5 to 0.6 litre of SAE 30 brand
oil. Insert the dipstick into the oil filling opening and push it
down to the thread. Pull out the dipstick. The oil must reach the
"Max" mark on the dipstick (no oil above "Max" mark). Screw
in the dipstick.
Filling with Petrol
L
Do not smoke - no naked flames!
off engine.
Avoid spilling petrol when engine is warm.
Use „low-octane petrol“ (do not use Super Plus).
Avoid petrol spillage.
Do not inhale vapour.
Hanging the grass bag
M
Attach and remove the bag only when the engine is
switched off and the cutting gear is standing still!
1. Lift the protective flap.
2. Attach the grass bag to the holders attached to the
chassis (see arrow).
3. Lower the protective flap.
Use of height adjustment
N
O
Only when mower is stationary and rotating blade
has come to complete standstill.
Campus 400 B
• Remove the front and rear wheels and remount them at the
same height
N
.
Campus 440 BA
• Front wheels: Remove both wheels and remount them at
the same heigh
N
.
• Rear wheels: Pull the lever out and engage it at the desired
cutting height
O
.
The rear and front end of the chassis must be at
the same distance to the lawn.
Start
P
Q
R
• On a flat surface, if possible not in high grass.
1. Pull out the choke
P
.
2. Raise and hold the safety bracket
Q
(1)
3. Pull starter grip
R
and return it slowly by hand.
4. Push the choke back
as soon as the engine
has warmed up.
Wheel drive
1. Wheel drive on: Raise drive bracket
Q
(2).
2. Wheel drive off: Relapse drive bracket
Q
(2)
Stop Motor
Release safety bracket
Q
(1).
Tips for mowing
• To prevent strips of grass from being left unmowed, the
cutting paths must always overlap a few centimeters.
• Always turn the mower on a surface that has already been
mowed.
Emptying the grass bag
Only when mower is stationary and rotating blade
has come to complete standstill.
The grassbox is full and should be emptied as soon as grass
clippings remain uncollected on the ground behind your mower.
Maintenance
Disconnect spark plug cap and starter key before
proceeding
Clean mower thoroughly after each mowing with cloth or
brush.
Do not spray with water. Keep mower in a dry room.
Cleaning mower and changing blade
1. Remove the spark plug.
2. For cleaning and blade change, position the mower as
shown in figures.
Change of Cutter blades
Disconnect spark plug cap and starter key before
proceeding
Blade should always be sharpened by an approved Service
Centre. Change blade according to drawing.
