Wolf Garten Campus 1000 V, Оригинальная инструкция по эксплуатации

Страница: 11 / 24

11
G
Operation
Operating times
z
Please check noise abatement regulations prevailing in your
country.
Feed cable through the strain relief
z
Please feed cable through the strain relief.
Connecting to the mains (230 Volts, A.C., 50 Hz)
z
The mower operates from any normal household mains sup-
ply, provided with a 16 Amps. fuse.
3
Note: Residual current protection device
These protection devices safeguard while touching
damaged wires, from insulation flaws and in certain cases,
also while damaging live wires.
z
We recommend that the equipment only be plugged into
a power socket, which is protected by a residual current
protection device (RCD) with a residual current of not
more than 30 mA.
z
Retrofit kits are available for old installations. Consult an elec-
trician.
Setting the working depth
1
Make sure the motor is switched off and the cutting bla-
des are not moving.
1. Pull the lever out.
2. Set the desired working depth.
3. Press the lever back in.
Recommended working depths
Starting up the engine
1. Depress button (1) and hold.
2. Lift up bar (2) and release button (1).
Switch-off motor: Release bar (2).
1
Important:
Place the cable fi rmly off the lawn or on the already cut side of
the lawn when starting to mow.
Attach grassbox
Lift protective flap, hook grassbox with the hooks provided into the
holes in the chassis (see arrow), reattach protective flap.
Maintenance
General
1
Attention! Rotary cutter blade
Before all maintenance and cleaning work:
z
pull out the power plug.
z
Do not touch running blades.
Cleaning
z
Clean the unit thoroughly with a brush after each use.
z
Do not spray with water.
z
Store unit in a dry room.
3
We recommend
Allow a WOLF-Garten-service centre to check the unit in the au-
tumn.
E
F
Transport
10 mm
uneven lawn surface
- 4 mm
3
Note concerning blade
wear:
If the blades are visibly
worn down, two additio-
nal working depths can
be used.
1
Do not overload appli-
ance (reduce working
height if motor blocks)
G
H