Wolf cinema SDC-12, Руководство пользователя

Страница: 60 / 81

ECO Mode
59
SDC-12/SDC-15
Off
1 Hour
2 Hour
3 Hour
4 Hour
On
Off
On
Off
Power is not turned off.
Power is turned off automatically after 1 hour.
Power is turned off automatically after 2 hours.
Power is turned off automatically after 3 hours.
Power is turned off automatically after 4 hours.
Used when the projector is installed at higher elevations (appx. 3000 feet , or 900m above sea level).
Settings: On, Off
[Off]
Set.
Not set.
Minimizes power consumption in Standby mode.
Settings: On, Off
If there is no signal transmission or operation for 30 minutes while an image is projected, the power is turned off automatically.
Set to “Off” if RS-232C / LAN communication is performed or the HDMI link function is used in the Standby mode.
High Altitude Mode
Communication
Terminal
Network
Lamp Reset
DHCP Client
IP Address
Subnet Mask
Default Gateway
MAC Address
Set
5-1 Network
Trigger
Off Timer
5 Function
Off
On (Power)
On (Anamo)
Configures 12V output to an external device (ex: motorized screen equipped with a trigger function].
Settings: Off, On (Power), On (Anamorphic)
[Off]
No output.
When projector power is turned on, a 12V control pulse is emitted from the trigger output.
When turning off power, the output of the 12V control signal stops.
During standby mode, an output will occur if the OPERATE button is pressed. After cooling, the output stops
[as the projector returns to standby].
Control signals (12V) are emitted when the Anamorphic mode is set from “Off” to “A” or “B”. If the Anamorphic mode
is set to “A” or “B”, the operation in this state equals “On (Power)”.
Establishes a system Power Off Timer.
* If there are no operations, the unit powers off automatically.
* It powers off automatically even while projecting an image.
Settings: Off, 1 hour, 2 hours, 3 hours, 4 hours
[Off]
RS-232C
LAN
On
Off
Determines the control terminal to be used. Only one terminal type may be used at one time.
Settings: RS-232C, LAN
[RS-232C]
Select the RS-232C port.
Selects the LAN port.
Network is displayed if LAN is chosen in “Communication terminal” submenu “[5-1] Network” is set to “LAN”.
Resets the lamp use timer to “0”.
Sets the DHCP client.
Settings: On, Off
[Off]
Automatically obtains an IP address from the connected network's DHCP server.
* The automatic retrieval starts with the "Set" within the menu.
The network settings are established manually.
Sets the IP address. [192.168.0.2]
Sets the subnet mask. [255.255.255.0]
Sets the default gateway. [192.168.0.254]
Displays the MAC address of the unit.
[5-1] Reflects the network setting.