Page
14
7.
Ethernet
:
The 10/100M Ethernet connector is used to connect with a
computer to modify the display settings remotely. CAT5 network cables are
recommended for medium distances. CAT6 twisted pair shielded cables are
recommended for longer distances.
8.
RS-485 In/Out
:
These RJ-45 jacks are used for dynamic Tally/IMD controls.
Two jacks are provided for in & out daisy chain arrangements. They are
wired identically. Refer to Figure 2-5 below for the pinout and Table 2-2 for
terminal connections. These connections are also used for system software
upgrades. Either CAT5 or CAT6 cables may be used for these jacks.
9.
Tally
:
This RJ45 jack controls the tally lights on the front panel. Refer to
Figure 2-5 below for the pinout and Table 2-1 for the terminal connections.
Either CAT5 or CAT6 cables may be used for these jacks.
Rear Panel Connectors
The following figure and tables detail the connections of the Tally and RS-485
connectors on the rear panel. The tables are also silkscreened on the rear panel of
the unit for your convenience.
Table 2-1: Tally Input Connections
Figure 2-5: Tally Input & RS-485 I/O Pin-Out
Pin
Tally Terminal Name
1
CH1-Red
2
CH1-Green
3
CH2-Red
4
CH2-Green
5-7 NC
8
GND