Page
13
1.
SDI / CVBS In 1
:
This input connector accepts 3G/HD/SD-SDI video
signals. It is compliant with SMPTE 424M, SMPTE 259M, SMPTE292M/ITU-R
BT601. This BNC jack also accepts a CVBS signal and automatically detects
it.
2.
SDI / CVBS Connector 2
: The function of this connector depends upon the
model:
a)
SDI 1 Out
:
On the RM-3270WS-3G, a re-shaped and re-clocked
duplicate of the SDI 1 input signal is generated from this BNC jack.
Refer to Figure 2-3. This connection is compliant with SMPTE 424M,
SMPTE 259M, SMPTE292M/ITU-R BT601.
b)
SDI / CVBS In 2
:
On the RM-3270WS-3G2, there is a second
3G/HD/SD-SDI video signal input. Refer to Figure 2-4. This
connection is compliant with SMPTE 424M, SMPTE 259M,
SMPTE292M/ITU-R BT601. This BNC jack also accepts a CVBS signal
and automatically detects it.
3.
L/R Audio In1 and In 2
: Two pairs of analog audio inputs are provided on
RCA jacks. They have a 47KΩ input impedance and will accept up to a 5dBu
signal.
4.
L/R Audio Outputs
:
A pair of analog outputs is provided on RCA jacks to
output the audio from the selected analog or digital video source. These
outputs have a 500Ω output impedance and will produce up to a 5dBu signal.
5.
Left and Right Speakers
: The left and right speakers for the unit are
located on the rear panel.
6.
Power Connector
:
The supplied 100 to 240VAC to 12VDC power supply
plugs into this coax connector. The connector is retained by a threaded
fitting.
Important:
The monitor and power adapter have been tested as a combined
apparatus to verify compliance with applicable safety and
electromagnetic compliance standards. Use of another power adapter
provided by the user may negate the compliance or not perform
properly. Wohler Technologies cannot accept any responsibility for the
outcome in such cases.
Important:
By design, the supplied AC mains power cord will only plug into a
three-prong grounded outlet for your safety. If the plug does not fit
into the outlet, contact an electrician to replace the obsolete outlet.
The symbol to the left warns of electric shock hazard inside or outside
the unit. Disconnect the power cord before removing access panels.
Note:
The left LCD must be turned on for audio to function from either the left
or the right screen, because the audio amplifiers are powered from the
left LCD. So, if only one screen is to be used, be certain that it is the left
one.