Wohler AMP2-16V-M, Руководство пользователя

Страница: 12 / 172

Page 5
Setting Up Your Monitor for the First Time
To set up your monitor quickly and efficiently, we recommend that you set up your
initial configuration in the order listed below.
1. Configure the Monitor Mixer: Select the inputs to be monitored.
2. Create channel clusters: Cluster the monitored channel meters to make them
most readable.
3. Arrange the Main Screen: Configure the Main Screen arrangement.
4. Select the metadata to display on the screen (if you want to display
metadata).
5. Save your setup into a preset.
Press the Menu button on the Main Screen to display the Configuration
Selection Menu.
1. Configure the Monitor Mixer
While the Monitor Mixer Configuration Menu ( Figure 1–5 ) provides a number of
feature adjustments, only a few are needed for you to get started. (The other
feature adjustments are explained later in this manual in
Chapter 5 : Menu List .)
Figure 1–5: Monitor Mixer Configuration Menu
Monitor Mixer Configuration Menu
Save / Exit Help Cancel
Chan 1 Chan 2 Chan 3 Chan 4
Slot 2 SDI-3G In
Pair 4
Slot 2 SDI-3G In
Pair 5
+0 +0 +0 +0
Channel
Trim
Source
Pair
Select
Phase
LED
On/Off
Delay to Speakers = 170 mS
Audio
Delay
Dolby 5.1
Speaker
Mute:
Off
L Front R Front Center LFE
Channel
Func
Mixer
Channel
Select
Set
Clusters
1. To get to the Configure Monitor Mixer Menu, press the Menu button to
enter the Configuration Selection Menu and then press the Configure
Monitor Mixer knob.
2. Before setting up the monitor mixer, it is wise to plan where you want each
channel you need to monitor to appear on the metering screen. Table 1–1
may help.