© 2010 Wohler Technologies, Inc. All rights reserved.
17
AMP V Series User Guide
Line Level Calibration Instructions
•
AES Out from SDI
(1 and 2, on BNC): These two unbalanced (75
) loop-through connectors each output a copy of the de-embedded
audio from the SDI input.
•
AES Termination
(Four-Position DIP Switch): This DIP switch sets
the termination for the AES inputs. If an AES input channel is fed to
downstream equipment, the associated DIP switch must be in the
up position (unterminated). If no downstream equipment is
connected, the switch must be in the down position (terminated).
See
Figure 1–8
for details.
•
SDI In and Out
(BNC-F): This unbalanced (75
) input connector
receives standard SD-SDI signals. The unit monitors Subgroup 1
(Channels 1 and 2) and Subgroup 2 (Channels 3 and 4) of SDI
Group 1. Note that the unit will monitor the SDI input only when
the
Analog/Digital
source select switch is set to
Digital
, and the
AES/SDI
digitial source select switch is set to
SDI
.
The unbalanced (75
)
SDI Out
loop-through connector outputs a
reclocked copy of the signal entering the
SDI In
connector.
•
Analog Out from Selected Digital Source
(3-Pin Phoenix Male,
Outputs 1 through 4): The balanced (75
) connectors ouput analog
signals converted from the selected digital inputs (but not the
analog inputs). These outputs are
not
affected by the position of the
Analog/Digital
souce select switch. The pin-out is silk-screened
onto the the rear panel.
Line Level Calibration Instructions
Figure 1–11
Calibration Settings
