© 2010 Wohler Technologies, Inc. All rights reserved.
20
AMP V Series User Guide
Internal Switch Settings
Internal Switch Settings
After removing the top cover, you can access DIP switches that control
level meter settings and/or calibration settings.
This 10-position DIP module is located on the 919174 PCB (See
Figure
1–13 on page 21
for the location.) Refer to
Figure 1–12
below for a
complete list of settings and functions. (Switch positions 1 and 10 are
not used and should be left at the factory set position.)
Figure 1–12
10-Position DIP Switch Settings
Scale Selection
The standard scale used on the 30-segment bar graph display for the
Extended VU scale. However, if alternative scale characteristics are
selected for the level meters by setting the Alternate Scale DIP switches
(
Figure 1–12
above), it is recommended that a label with the
appropriate scale be applied to the front panel LED bar graph level
meters. Alternate scales include the VU, BBC, Nordic, and DIN scales.
The Extended VU scale is the standard scale for all AMP V Series
models. See
Figure 1–14
and
Figure 1–15 on page 22
for alternate scales.
Contact Wohler Technologies for more information about Alternate
Scale labels.
