24
If you choosed the Select All before you push the Write config then all listed parameters were sent.
(The further – not listed - parameter grousp will be not sended.)
If you wouldn’t like to send all listed parameter to the device then push to the Deselect all
and mark only the required parameters on the parameter groups which you are attempt to
sended. Then push the Write config button. Only the selected parameters will be sent.
The detailed parameter description can be found in the next Chapter.
4.6 Firmware upload/refresh
When you are attempted to upload a newer software to the
Easy
2S NB,
then
choose the Firmware
update tab from the
Configuration upload
window
(4).
Before uploading a firmware file, always ensure about the SW VER (software version) at left side of
the screent (2) which should be older than the version which are attempted to upload.
The refresh can be performed through the USB serial port (when it was connected on Serial
Port), via TCP IP (when it was connected through TCP-IP (GPRS)). The program will
automatically handle it. During a TCP/IP firmware refresh the
Easy 2
will send installation
progress codes.
In case of firmware upload from the serial port, Browse
the required firmware binary file (the
filename contains the software version – e.g. EASY2S_V23R08I09NB.bin – means version
„V23” means 2.3 version, „R08” = main version nr. 8, „I12” = impulse software version nr. 12
and „NB” as Narrow Band module version).
To start the firmware upload method, push the Upload button.
Then the
Easy 2S NB
will receive the firmware file through the serial connection and starts to
refresh its system software.
