16
2. Operating Procedure
Note that the burner orifice (
2
) and the burner tube (
3
) remains hot after the flame has
been extinguished.
Do not touch. Can cause burns.
Point the burner away from body and flammable objects.
The unit is ignited by gradual pressure on the trigger (
4
). Maintain pressure throughout the
flame-off procedure. Disconnect the unit before leaving it unattended.
The flame can be varied in size by turning the gas controller (
1
).
The flame is extinguished upon release of the trigger (
4
).
The trigger (
4
) is equipped with a locking device (
5
). The locking device is pushed side
wards when trigger (
4
) is pressed. To release locking device press trigger (
4
).
!
!
3. End of operation procedure
After use or for any longer period of time without attandance, ensure that the gas controller
(
1
) is shut completely. (Turn the gas controller (
1
) in clockwise direction to the stop
position). Disconnect the gas cartridge from the powerjet.
4. Exchanging the gas cartridge
Ensure that the flame is extinguished, the burner has cooled down and no other flame is
nearby. Shut off the gas controller
(1)
completely. (Turn the gas controller (
1
) in
clockwise direction to the stop position).
Screw the empty gas cartridge (
8
) out of the powerjet.
After, press again the trigger (
4
), to be sure that no gas is left in the powerjet.
Attention: The burner can ignite a flame shortly.
Check the sealing (
7
). Replace the sealing if damaged or worn.
(Sealing for powerjet,
Art.No.: 6.005.010
)
Connect the new gas cartridge to the threaded adapter (
6
) of the powerjet. Keep the gas
cartridge (
8
) upright when fitting it to the threaded adapter (
6
).
Place the threaded adapter adequately on top of the gas cartridge valve. Gently screw the
gas cartridge into the theaded adapter. Be careful not to fit the gas cartridge cross
threaded.
NOTE! Screw hand tight only. Do not over tighten or you will damage the
threaded adapter of the powerjet or the gas cartridge valve.
!
!
NOTE! Screw hand tight only. Do not over tighten or you will damage the
threaded adapter of the powerjet or the gas cartridge valve.
Pay attention that the gas connection is gas-tighted.
Temperature range when using cartridges is +10°C to +35°C. (50°F to 95°F)
!
!