WLD-TEC Fuego, Инструкция по эксплуатации, Страница: 27 / 60

27
i
2.3 [Fuego basic RF] Radio foot pedal activation and function
Switch the burner off prior to operation to prevent inadvertent activation
of the burner.
Remove the transport insulation from the batteries (21a) prior to first use. The two
mignon batteries (AA) have already been inserted into the battery compartment of, the
wireless foot pedal
(21)
.
The LED's Standard (3) and Start-Stop (4) will flash alternately until a wireless foot
pedal has been detected within range (2 - 5 metres).
Once the transport insulation has been removed, switch burner on again. The wireless
foot pedal does not have a mains switch, but is automatically switched on when
operated. The foot pedal also deactivates itself after a certain time once the laboratory
gas burner has been switched off.
The radio system can be used without changing any further settings as the laboratory
gas burner and the wireless foot pedal have already been programmed to each other
(gas burner and foot pedal programming , see paragraph 2.5) by the manufacturers.
The laboratory gas burner is started as soon as the foot pedal is operated
and the LED's (3) and (4) stop blinking. Attention: Flame!
The corresponding LED for the foot pedal program (3) or (4) that has been selected will
also light up continuously in green and signals that the wireless foot pedal is connected
to the appliance. (In cases the alternate flashing continues after operation and the foot
pedal is not being detected,
(see paragraph 2.5.) .
The LED's "Standard" (3) and "Start-Stop" (4) of the laboratory burner will flash
alternately as soon as the wireless foot pedal is no longer within range (2 – 5 metres)
or the radio signal is interrupted. In this case the flame will be switched off automatically
for safety reasons.
As an alternative, the burner can also be operated using a tethered foot pedal
(optional): In this case, plug the foot pedal cable into the foot pedal connector
(8)
on the back of the burner. The burner will detect the foot pedal and the alternate
flashing of the LEDs Standard
(3) and Start-Stop (4) will cease as soon as the
foot pedal has been plugged in.
!
!
i
2.4 [Fuego basic RF] Function LED on the radio foot pedal
The function LED (20) flashes at different intervals to indicate different operational
status.
No LED lights up:
The foot pedal is deactivated / switched off.
Brief, faint flashes:
Fully functional, unimpeded radio transmission.
Brief, intense flashes: Renewed radio transmission at weak radio
signal strength or signal overlap.
Brief, intense flashes at
rapid set intervals: The RF stick is out of range or has been switched
off. If no burner is detected after 40 flashes, the foot
pedal will be switched off automatically.
EN