Wittus MCZ, Техническое учебное пособие

Страница: 4 / 28

First Lighting

Set the Date & Time
Instructions for setting up the date, time, & programming on the black panel or remote are included in the
stove manual. A simplified version in provided in the Quick Start Guide (available at wittus.com).

Priming the burn pot
Place 1 handful of pellets in the burn pot for the initial firing. This allows time for the auger to prime and
maintain combustion. If the stove goes into Alarm 01 (failure to ignite) you must reset the stove and try
again. Too much fuel in the burn pot can also be a problem.

Start Up Phase
In the start up phase the stove will run at power level 3 with the fan speed at level 3. Adjustments to the
power or fan speed can not be made in the start up phase which can take between 10 to 15 minutes.
When the stove starts automatically in thermostat or program mode the fan speed goes to its previous
setting after the start up phase.

Curing the paint
As with most pellet stoves, it will take several hours to cure the paint. The paint on the stove will be soft
until cured. To avoid finger prints do not touch the stove until the paint has had a chance to fully cure. It is
advisable to ventilate the room.

Alarms
An alarm indicates a problem with the stove or flue system. An alarm will make a beeping sound for 10
minutes and stop. After that the Alarm code will appear on the control panel. Most alarms will shut off
the stove. If an alarm is triggered the control panel must be re-set by switching the stove off for 10
seconds. Otherwise the stove will not run.