Wittenstein cyber motor cyber dynamic 17, Руководство по эксплуатации

Страница: 26 / 30

Appendix II cyber
®
dynamic line
en-24 5022-D029179 Revision: 04
1 Attachment recommendation
deutsch
english
italiano
français
español
日本語
10 Appendix II
10.1 Attachment recommendation
As the specific installation situation at the customer site is not known, the following attachment
recommendations are only to be regarded as examples.
WITTENSTEIN cyber motor GmbH does not assume any liability for constructive integration by
the customer.
10.1.1 Attachment recommendation: Standard (IP54)

As the shaft end has a lower protection class (IP20), design measures should be implemented
in the unit to protect it from dust and spraying water (e.g. encapsulation in the unit). If this is not
possible, it is recommended that you use a drive with a higher protection class.
By default, cyber
®
dynamic line Standard
features
- protection class IP54 on the cable outlet side
(B),
- protection class IP20 on the customer outlet
side (A).
To also achieve protection class IP54 at the
connection to the application, the following steps
are recommended:

Incorporate a circular groove (E) into the
mountable flange (C).

Insert an O-ring into the circular groove.

Screw the cyber
®
dynamic line Standard to
the mountable flange.
 By tightening the screws, the O-ring is
squeezed and protection class IP54 is
ensured.

Dimensions and tightening torques can be
found in table "Tbl-1".
cyber
®
dynamic line,
Standard
Size 17 22 32 40
O-ring [mm] 15 x 0.5 20 x 0.5 30 x 0.5 38 x 1.0
Screws 4 x M1.6 4 x M2 4 x M2.5 4 x M3
Tightening torque
(A2-70) [Nm]
0.11 0.23 0.46 0.81
Tbl-1: Attachment of cyber
®
dynamic line, Standard