Witt WS955, Руководство пользователя

Страница: 79 / 84

~ 79 ~
Maintenance
An accurate maintenance guarantees good functioning and long-lasting
performance. Special care needs to be taken with the grease filter: to access
the filter, proceed as described in the PANEL OPENING chapter.
Remove the grease filter, using the special handle. To refit the grease filter
after cleaning, carry out the same operation in reverse order. To remove the
carbon filter, if fitted, follow the same steps as for the grease filter. The
carbon filter is located immediately above the grease filter.
Tepid water and neutral detergents are recommended to clean the
appliance, while abrasive products should be avoided.
PANEL REPLACEMENT
The panel replacement is done by first opening it as indicated in chapter
opening panel; in the case of the LIGHT panel, you must disconnect the
power from the mains and unplug the power cord of the lamps by acting on
the electrical connector located right above the panel.
Remove the two locknuts securing the panel (see fig. 10) and slide the panel
to the right to remove it from its seat. To place the panel back into position,
follow the above described procedure in reverse order.
REPLACING LAMPS
To replace the damaged fluorescent lamps you must unplug the product from
the mains, then open the panel by following the instructions in the chapter
“PANEL OPENING”.
Remove the six perimeter screws of the panel and open it as shown in figure
11; proceed in replacing the fluorescent lamp using a lamp with the same
characteristics. Put back into position the panel and the screws you
previously removed.
For the replacement of the fluorescent lamps feeder, act in the same way as
described above, since the feeder is positioned next to the lamps.