Witt 21660079, Руководство пользователя

Страница: 65 / 72

~ 65 ~
Standard configuration
If two cookerhood radio control systems are installed in the same room or in
the immediate vicinity, each system may affect the operation of the other,
due to the fact that they have the same code. Therefore it will be necessary
to change the code of one of the radio controls.
Warning:
The battery should be replaced every year to guarantee the optimal range
of the transmitter. To replace the exhausted battery, take the plastic lid off,
remove the battery and replace it with a new one, observing the correct
battery polarities. Used batteries should be discarded in special collection
bins.
Emergency button:
In case of radio control malfunctioning, to switch off the appliance just press
the emergency button (Fig. 16B) placed near the lighting lamp. After fixing
reset the emergency button.
The luxury products are endowed with an electronic device which allows the
automatic switching off after 4 hours working from the last operation.
Generating a new transmission code
The radio control is supplied by the manufacturer with default codes stored.
If you want to create a new set of codes, proceed as follows: press and hold
the UP, STOP and DOWN buttons simultaneously for 2 seconds. After the
LEDS light up, press the UP and DOWN button within 5 seconds. The LEDS will
flash 3 times to indicate that the process is completed.
WARNING: This procedure deletes all previously stored codes.
Learning the new transmission code
After changing the transmission code on the radio control, the cooker hood
electronic control unit must be made to set the new code as follows:
Disconnect the appliance from the electric network and then re-connect it ;
press the light key within the next 15 seconds, in order to synchronize the
cooker-hood with the new code.