- 33 -
Settings Dual QAM with CI
(Key code X061 with transport stream handling)
OV75M A/B=channel
1237MHz=input frequency A/B
479.00=output frequency A/B,
<1.0e-4=BER, alternating display
Channel
OV75M
V1.00
busy
channel
A/B
FE-all:
The complete transport stream of the front end
is used
FE-sel:
Only programmes selected in the “Prog” menue
are used
ASI-all***:
The complete transport stream of the
ASI module OV 67 is used
ASI-sel***:
Only programmes selected in the “Prog” menue
are used
Source
OV75M
V1.00
Ch. A
Insert here - input modules settings
F-Out*
Offset**
45-862 MHz
,
1MHz steps
4-8 MHz
- Offset,
Bsp.:Ch A = 471,25 MHz + 8MHz-Offset=Ch B
loop
= Loop through mode
single
= Single output
1.000-7.499 kBaud
?Symbol rate?
Incorrect symbol rate
?????
refer to note
on/off
on: Signal switched on
off: Signal switched off
OUT-Att*
0-15 dB
Output level, 1dB steps
OutConf*
QAMRate
Carrier**
QAMSpec
normal / inverse
16, 32, 64, 128, 256 QAM
type of modulation
QAMMode
(2)
Prog****
Displays the list of transponder name.
Select programme with
.
A
*
confirms the selected programmes.
Important: Select one programme per channel
If
!Overfl.
is displayed , (total data rate to high)
reduce the programme numbers.
T=tv
R=radio
#=encrypted
CI
Displays the list of transponder name.
Select the programme to be decrypted with
.
A
*
confirms the selection.
T=tv
R=radio
#= encrypted
*
only at channel A
**
only at channel B
*** only with integrated
ASI module OV67
**** only when "FE-sel" or
"ASI-sel" are selected in
the "Source" menue
Operation
Select the menu item and
adjust the values in a menu line
with the UP/DOWN keys
.
Enter values and enter and exit
from menu lines with the LEFT/
RIGHT keys
.
Exit the second level with
.
Saving: Data are saved
automatically. Data are retained
in the case of a power failure.
