User Manual
2021 Release 2
WiseAir Technologies India LLP
[email protected] +91 90477 78715
Page 12 of 20
WADS SERIES
DEW POINT SENSOR
MEASURE TO MANAGE
6.3 Step 3 — Attach Dew Point Sensor To Pipe
The dew point sensor's measurement chamber comes with a quick
release coupler. This can be removed and the chamber connected directly to a
valve with 1/4" male BSP fitting, if required.
Connect the sensor to the measurement chamber. Screw the
measurement chamber into the pipe connection point (eg valve, nipple or
nozzle) If using a valve, op
6.2 Step 2 — Install the Socket and Ball Valve
To install the sensor, you need a connection point to the pipe, eg a valve
or a nozzle or nipple. The inner thread must be G 1/4".
Use of a valve is optional - You do not need to use a valve to install the
sensor. However, using a valve will make removing the sensor easier (eg when
you need to remove the sensor for calibration).
M12 / M8 Connector
Dew Point Sensor
Measurement Chamber
Bleed Screw
Nitto fitting can be
removed, if needed
Ball Valve
(diameter of the hole must be
> 13mm
Dew Point Sensor tip