wirsbo proMIX 101, Руководство по установке

Страница: 33 / 56

PROGRAMMING - STEP 2
TEST SEQUENCE
The proMIX 101 has a built-in test routine which is used to test
the main control functions. The control monitors the sensors
and displays an error message whenever a fault is found. See
Appendix III (page 50) for a list of the proMIX 101's error
messages and possible causes. When the test button is
pressed, the test light is turned on. The outputs and relays are
tested in the following sequence:
• Each step in the test sequence lasts between 10 and 20
seconds
• To reach the desired step, repeatedly press and release the
Test button until the appropriate device and segment in the
display turn on
Step 1
• The floating action valve will move to the fully open position
Step 2
• The valve will move to the fully closed position
Step 3
• The mixing pump (P1) is turned on for 20 seconds
Step 4
• The boiler contact is turned on for 10 seconds. After 10
seconds, the boiler and mixing pump contacts are shut off.
Step 5
• After the test sequence is completed, the control resumes its
normal operation
31
PROGRAMMING
PROGRAMMING - Step 2 - Test Sequence
NOTE:
Before you begin testing,
all appropriate settings must
be entered into the control
using the LCD screen. If
you are unfamiliar with the
theory behind a hydronic
radiant heating system, please
refer to the Control Function
Overview for more help.