WT5105-M1-DK
5 / 11
Wireless-Tag Technology Co., Limited http://www.wireless-tag.com
2.
Hardware description
The front view and back view of wt5105-m1-dk are shown in the figures below. The self-locking switch
SW1 is used to switch the power supply of the module: when SW1 is pressed, the module is powered by
the USB interface; when SW1 is released, the module is powered by the button battery on the back of the
development board. The touch buttons S1 and S2 are used to control the level status of the TM pin and
RST pin of the module: RST is connected to GND when S1 is pressed (RST is high level by default); TM is
connected to VCC when S2 is pressed (low level by default). The J5 pin header is connected to RST and
TM respectively.
The front view of WT5105-M1-DK
