Wintriss SmartPAC PRO, Руководство по установке

Страница: 47 / 92

SmartPAC PRO Installation Manual 1143200
Chapter 2 – Installing SmartPAC PRO 47
Sensor screen, shown in Figure 2-19, displays.
5. Check to make sure that the setting for the POSITION SENSOR MODE item is DISABLED. If it
isn’t, press ENTER to toggle to the DISABLED setting.
Figure 2-19. Position Sensor Screen
6. Press RESET twice to return to the Main Program Menu.
7. Create a tool, following the steps in Creating a New Tool in Chapter 4, Program Mode, of
your user manual.
8. Enter a counter preset of 10,000 for the tool, following the directions under COUNTERS in
Chapter 4, Program Mode, of your user manual..
9. Load the tool, following the instructions under Loading a Tool in Chapter 4, Program Mode , of
your user manual.
10. Access the Position Sensor screen again (see steps 4 and 5).
11. Check the CURRENT RESOLVER ANGLE setting. If it is not zero (0), inch the press until it
reads zero.
NOTICE
The crankshaft angle reading should increase as you inch the press. If it decreases (359

, 358

,
357

, for example), swap the black and yellow wires (terminals 213 and 216) on connector TB3 on
the SmartPAC PRO board (see Table 2-1, page 25 and Figure 2-5, page 22).
NOTICE
The press must be at top dead center (0°) before the position sensor can be installed. Make sure
that the CURRENT RESOLVER ANGLE setting is 0° before proceeding to the next step.
12. Shut off power to SmartPAC PRO and the press control.
13. Mount the magnetic switch so that the magnet rotates 1:1 with the crankshaft of the press. The
ideal location is on the crankshaft itself.