Wintriss SmartPAC 2, Руководство пользователя

Страница: 78 / 604

1128600 SmartPAC 2 with WPC 2000 Integration User Manual
2-34 Installation
Connecting Other Wintriss Products to WPC 2000
You can connect the stop circuits of other Wintriss products to WPC 2000. Before you wire,
complete all WPC 2000 installation, initialization and checkout procedures. Then run the
press in all modes of operation–Inch, Single-stroke, and Continuous (if applicable). Also
make sure that the press has working Top-stop and Emergency-stop circuits. Since WPC
2000 is connected to the press stop circuits, it is extremely important to verify that the press
operates and stops properly before connecting WPC 2000 to other units. Do not forget to
mark on your electrical prints where you wire in WPC 2000.
When the Stopping Time is critical to your operation, as it is with die protection, be sure to
wire as follows. Whenever you have Emergency-stop circuits, wire them between terminals
#67 and #68 or terminals #68 and #69 on the Main Processor board. For Top-stop circuits,
wire them between terminals #79 and #80 or terminals #80 and #81. Refer to Figure 1 at the
end of the manual for specific wiring schematics.
Use customized status code wiring (see
Wiring WPC 2000 User Inputs
, page 2-31) when the
auxiliary equipment that you are connecting does not have its own self-explanatory displays,
as are available in DiPro 1500 or AutoSet load analyzers.
Installing WPC 2000 Options
Wiring the Lockout Relay
The Lockout relay, which is designed to be wired to critical press functions such as the motor
starter (see Figure 6 at the back of the manual for an example), provides an added safety
feature to WPC 2000. Whenever a serious error condition occurs, the Lockout message will
appear in the SmartPAC 2 display. To clear the Lockout message, turn the Stroke Select
switch to OFF, then back to INCH or one of the other operating modes.
Wire the function you want to be controlled by the Lockout relay to TB 301 on the DSV/
Lockout relay board, which is located in the upper left corner of the WPC 2000 Main
Processor board (see Figure 2-14, page 2-28). Wiring connections are shown in Table 2-7 and
in Figures 16 (Herion DSV), 17 (Ross Serpar DSV), and 22 (Ross DM2 DSV) at the end of
the manual.
Table 2-7. Lockout Relay Wiring Connections (DSV/Lockout Relay Board)
DSV/Lockout Relay Bd.
TB301
Pin # Signal
97 Lockout relay input
98 Lockout relay output
99 Lockout relay output