Wintop iDoorSensor, Быстрый старт

Страница: 5 / 8

Version 0.2 1
Maximum supported nodes per group: 5
Group1: if the internal door contact (magnet) is triggered it sends a Z ‐ Wave frame to every node in this group
Group2: if the external door contact is triggered it sends a Z ‐ Wave frame to every node in this group if it is
configured (see configuration documentation param 2: external contact).
Class: 0x80 COMMAND_CLASS_BATTERY
This class is used to request and report battery levels for a given device.
When battery level is lower then 20% the Door Sensor will send a battery warning (value 255) after every wake
up notification. A battery get will report the actual value even if below 20 %
class: 0x84 COMMAND_CLASS_WAKE_UP
The Wake Up Command Class is used at battery ‐ operated devices. This class allows the DoorSensor to wake up
occasionally to notify others devices, that the DoorSensor is ready to receive commands. After receiving the
commands the DoorSensor will go into sleep mode again. The wake up interval can be set using the
WAKE_UP_INTERVAL_SET command.
The default value is 0x1C20 = 7200 sec = 2 hour
The default node is 0xFF = 255 (broadcast)
It is possible to send a wake up notification on user interaction. To do this press and hold the tamper switch
for 8 seconds.
When the wake up time is set to 0 a wake up notification is never send periodically, only on user interaction.
class: 0x31 COMMAND_CLASS_SENSOR_MULTILEVEL
Sensor_multilevel_get
The Sensor Multilevel Command Class is used to get a report from the Door Sensor. The returned value is the
measured temperatue inside the housing with 2 decimals.
class: 0x71 COMMAND_CLASS_ALARM
This command class is used to identify the state of the tamper alarm. The device will send an unsolicited report
to the controller if the status is changed, the value 0x00 will indicate that the tamper is placed correctly on the
wall. The value 0xFF will indicate a tamper alarm.
There are 2 different alarm types:
2: External door contact
3: Tamper switch
Every other alarm type that is requested will be ignored by application.