Winterhalter PT-L, Руководство по эксплуатации

Страница: 12 / 44

Integral water softener (special equipment)
10
Procedure :
Danger

Observe the safety precautions when handling chemicals and the dosage recommendations
on the packaging.

Wear protective clothing, protective gloves and protective goggles when handling chemicals.

Do not mix different detergents.

Remove the suction tube from the container and place it in a water-filled container.

Rinse the dosing tube and the detergent dosing device with water. To do this, use the "prime dosing de-
vice" function several times (

‎
10). The frequency depends on the length of the dosing tubes.

Place the suction tube in the new detergent container.

Use the "prime dosing device" function several times (

‎
10), to replace the water in the dosing tubes with
detergent.
5.5 Priming the dosing devices
Dosing devices must be primed when air is reached in the dosing tubes because the containers were not
exchanged or refilled in time (

‎
10).
6 Integral water softener (special equipment)
By softening the inlet water, limescale build-up in the machine and on the dishes is avoided. For the integral
water softener to work correctly, the salt container must be filled with regeneration salt.
INFO At the commissioning of the machine the authorised service technician measures the water hard-
ness and saves it in the machine's electronic control unit.
6.1 Lack of salt display
A pictogram appears on the screen when an empty salt container requires refilling. The dis-
play disappears after filling the salt container, as soon as approx. 3 wash cycles have been
completed and part of the salt has been dissolved.
6.2 Filling regeneration salt
Caution
Possible risk of damage to the water softener
Chemicals such as detergent and rinse aid inevitably lead to damage to the water softener. Fill
only with regeneration salt or pure evaporated salt.
Possible malfunction of the water softener
Do not fill with other salts (e.g table salt cleaning or de-icing salt). These can contain water-
insoluble components. Fill only with fine-grained salt (max. 0.4 - 7 mm grain size).
INFO Because of their size, salt tablets are not suitable.

Proceed in accordance with Figures A1 to A5.
IMPORTANT Figure A2 is only relevant for the first filling.
Caution
Risk of rust formation in the filling area
Immediately after filling, start a wash cycle to rinse off any salt residue.