3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
Lift and remove vent back.
Remove the seven (7) screws securing Danger Label panel and either left or right back
panel (Servicer preference) to rear of fryer.
Remove weight from weight lifter.
Disconnect the two (2) vent solenoid
wires from harness wires at insulated
terminals (See Figure 17).
Remove the four (4) screws securing vent
block to vent assembly. Save screws,
block and ball (if applicable) for reuse.
NOTE:
Some 4-Head and 6-Head
models utilize a stainless steel
vent ball (Iocated on vent block) with
weight to regulate pressure.
Remove vent tube O-ring and save for
reuse (See Figure 18).
Remove the four (4) screws securing
vent assembly to rear of fryer and save
for reuse. Leave vent block nut plate
on vent tube for further use.
Remove vent spring and save for reuse.
Note how spring is mounted to bracket
and weight lifter to ensure proper
installation when replacing.
Remove defective cotter pin releasing
weight lifter arm from solenoid plunger.
Install new cotter pin in solenoid plunger
capturing weight lifter. Spread cotter pin
to prevent disengagement of plunger and
lifter arm.
Replace vent spring securing weight lifter
to solenoid bracket. Vent spring is mounted
between notch in top of vent solenoid bracket
and hole in weight lifter arm.
NOTE:
Utilize care in preventing spring from twisting when replacing. This could
create undue tension resulting in a loud chattering noise and pressure reduction during
cook cycle.
Manually depress and release weight lifter several times to ensure smooth unrestricted
travel prior to reassembly.
FIG. 17
FIG. 18
WINSTON
43
LIT.6710/REV.0/9-91
Содержание OF49P32SJ
Страница 6: ...Behind 43 37 38 39 40 41 44 If Applicable 42 WINSTON 6 LIT 6710 REV 0 9 91 NOTE 6 Head Model Picture...
Страница 7: ...WINSTON 7 LIT 6710 REV 0 9 91 45 46 47 48 49 50 51 52 53 54 55 Inside Behind...
Страница 8: ...WINSTON 8 LIT 6710 REV 0 9 91 62 Behind 57 56 58 59 60 61 NOTE 6 Head Model Pictured...
