Note how spring is mounted to bracket and
FIG.14
WINSTON
41
LIT.6710/REV.0/9-91
7. Remove the four (4) screws securing vent block and ball (if applicable) to vent assembly.
NOTE:
Some 4-Head and 6-Head models utilize a stainless steel vent ball (located on vent
block) with weight to regulate pressure.
8. Remove vent tube O-ring and save
for reuse (See Figure14).
Save screws, block and ball (if applicable) for reuse .
9. Remove the four (4) screws securing vent
Leave vent block nut plate on vent tube for
further use.
10. Remove vent spring and save for reuse.
weight lifter to ensure proper installation
assembly to rear of fryer and save for reuse.
when replaced.
11. Remove cotter pin releasing solenoid plunger
from weight lifter. Save cotter pinfor reuse.
12. Remove weight lifter and save for reuse.
13. Remove damaged or worn teflon slide from
lifter arm and replace with new teflon slide.
14. With teflon slide in place and weight lifter
in upright position, insert weight lifter arm
through slot in vent assembly. Insert cotter
pin through solenoid plunger and weight lifter
arm. Secure cotter pin in place by bending
(See Figure 15).
15. Replace vent spring securing weight lifter to
solenoid bracket. Vent spring is mounted
between notch in top of vent solenoid bracket
and hole in weight lifter arm.
NOTE:
Utilize care in preventing spring from
twisting when replacing. If twisted, undue
noise and pressure reduction during cook cycle.
16. Manually depress and release weight lifter
several times to ensure smooth unrestricted
travel prior to reassembly.
tension produced could result in a chattering
FIG.15
Содержание OF49P32SJ
Страница 6: ...Behind 43 37 38 39 40 41 44 If Applicable 42 WINSTON 6 LIT 6710 REV 0 9 91 NOTE 6 Head Model Picture...
Страница 7: ...WINSTON 7 LIT 6710 REV 0 9 91 45 46 47 48 49 50 51 52 53 54 55 Inside Behind...
Страница 8: ...WINSTON 8 LIT 6710 REV 0 9 91 62 Behind 57 56 58 59 60 61 NOTE 6 Head Model Pictured...
