PROGRAMMING
Our remote starter
is delivered with factory default settings. You can install it without programming or you can modify the
configuration to suit your customer’s need.
Important:
the installation must be completed before accessing
programming mode.
Programming the system:
1. Turn the ignition 3 times OFF to ON and leave the key in the ON position (engine not running).
2. Within 15 seconds, push 1 time on the antenna button. You will hear 5 beeps to confirm that the system is now in
programming mode. The L.E.D. built-in receiver will flash slowly.
Note:
If the 15 seconds delay has expired, just turn the ignition OFF and repeat steps 1 and 2.
The system has
25 programmable options
and there are 1 to 3 different possibilities to modify. (Except option #21 &
#22).
Step 1
Press then release antenna button to select option 1 to 25 (depend on models, see programming chart).
Every time you press on receiver button you will hear one beep. Count the beep to reach desired option.
Step 2
When you have reached the desired option depress brake pedal to confirm.
Step 3
Press button
,
or
on transmitter to choose between different possibilities (
to select column 1, you
will hear 1 beep,
to select
column 2, you will hear 2 beeps or
to select
column 3, you will hear 3 beeps).
Depress brake pedal again and count the beep to confirm that the feature has been changed.
Note: if you have more than one option to modify, repeat steps 1 to 3.
Step 4
When finished, Turn ignition OFF to exit programming mode. One long beep will be emitted.
8
