EXAMPLE 2, OPTION 20: TRANSMITTER CODE LEARNING
The transmitter supplied is already programmed to the system. This option allows you to add more transmitters to your
system if needed.
1. Access programming mode (see programming procedure).
2. Press and release program button 20 times and count 20 beeps.
3. Depress brake pedal to confirm. Blue L.E.D. built-in receiver will flash rapidly.
4. Press
button on the transmitter 1 time. You will hear 5 beeps. The new transmitter code is learned. If you press
on the same transmitter 4 times, all another previously stored transmitter codes in the system will be erased.
5. Turn ignition OFF to exit programming mode.
EXAMPLE 3, OPTION 1: FINE TUNING THE TACH SIGNAL
Even with the AUTO TACH learning features you can not reach the exact setting.
Example: idle is too high
. This option will
allow you to fine tune the TACH signal manually, make sure the engine is
not running
.
1. Access programming mode (see programming procedure).
2. Press and release program button 1 time and count 1 beep.
3. Depress brake pedal, you should hear the number of beeps according to Auto-Tach learning. You must count the
number of beeps, minimum 1 beep and maximum 10 beeps. If you miss the number of beeps, depress brake pedal
again to count the beeps.
Note
: In order to increase or decrease TACH signal level, you must carefully count the number of beeps when you depress
brake pedal. Decrease when TACH signal is weak and increase when TACH signal is strong.
PROGRAMMING EXAMPLES
16
