Example: you start the engine via the transmitter, if the engine is over cranking decrease the signal level. If the engine
releases too fast, increase the signal level.
4. Press
button on the transmitter to increase signal level or press button
to decrease signal level.
5. Depress brake pedal again to confirm the beeps, the number of beeps should be more or less than the number
counted in step #3. This confirms that you have changed the setting.
6. Turn ignition OFF to exit programming mode.
7. Start the engine via the transmitter to try the new setting. If you are still not satisfied, repeat step 1 to 6.
EXAMPLE 4, OPTION 3: REINITIALIZE TO FACTORY DEFAULT SETTING
In case of confusion or you want to install the system in another vehicle and you don’t want to keep the old settings. The
option 3 allows resetting of the system back to factory default setting.
1. Access programming mode (see programming procedure).
2. Press and release program button 3 times and count 3 beeps.
3. Depress brake pedal to confirm.
4. Press
button for Automatic vehicle (1 beep) or
for Manual vehicle (2 beeps) on the transmitter. Factory
default setting is reinitialized upon you select 1 beep or 2 beeps.
5. Turn ignition OFF to exit programming mode.
Attention:
After resetting to factory default, you have to perform AUTO-TACH learning signal otherwise you can not
remotely start the engine.
17
REMOTE ENGINE STARTER &
ALARM DIAGNOSTIC
