Antenna Systems
Winsig 3.1 Connector to coaxial cable installation
4.
Once the cable has been prepared, slip the provided push
-
on connector
over the cable. The cable must be installed as far as it will go, such that
the centre copper conductor protrudes from the end of the connector
by a few millimetres.
5.
Pull backward on the connector to ensure that the small tines have en-
gaged, and you connector is firmly in place.
Note: The provided connector is suitable for quad shielded RG6 coaxial ca-
ble. If the retainer tines on the connector have not engaged, your van may
have a smaller diameter (dual shielded) cable installed. As every van instal-
lation is different, we do not provide multiple connectors in each kit, howev-
er these connectors can be obtained by contacting us.
1.
Strip outer plastic cover 12mm from end of cable.
2.
Trim away all steel braid and aluminium foil until white plastic insulator
is exposed. Some cable has two layers of this braid and foil. All must be
removed.
3.
Remove 6mm of inner insulation, whilst being careful no to nick the cen-
tre copper conductor.
Note: a cable stripper designed specifically for coaxial cables will achieve a
neat and easy result if you have one, but this process can be achieved with a
sharp utility knife if care is taken.
Before commencing the preparation of your cable, slip the rubber protector boot onto the cable, and slide it out of the way to
allow easy access to the end to be terminated.
