Winplus Cocoon Create Model Maker HE170703, Инструкция по эксплуатации

Страница: 21 / 40

21
AFTER SALES SUPPORT
1300 663 907 CUSTOMERCARE@WINPLUS.COM.AU MODEL: HE170703
5.4 Removing Filament
Follow these steps to remove filament.
NOTE:
You do not have to remove filament after each print, however if you do not intend to print for
long periods of time, we recommend removing and storing filament in a resealable air tight bag
1. Turn on the 3D Printer with the power switch located at the back of the printer
2. Push the dial button to access the Main Menu and navigate to Quick Settings Change
Filament Remove Filament. The extruder will automatically raise and preheat; always wait
until it has fully preheated
3. After the extruder has preheated, hold the filament clamp on the top of the tower and push
the filament so a small amount begins to extrude
4. Once filament is extruding from the nozzle, while holding the filament clamp, quickly pull the
filament out of the extruder and tube
5. Store the filament in a resealable bag to protect it from moisture. For more filament storage
suggestions see page 29
FINISHING
6.1 Finishing Techniques
6.1.1 Useful Tools/Equipment
• Safety goggles
• Mask
• Long-nose pliers
• Wire cutters
• Sandpaper (100, 200, 300, 400, 500, 600 grit)
• Medium, fine and extra fine sanding sponges
• Acrylic based primer spray paint
• Acrylic based spray paint (colour of your choice)
• Acrylic based varnish spray paint
NOTE:
Different paint types are also compatible with PLA. Consult your local paint supplier for the best
compatibility for your intended purpose.
PRINTING AND REMOVING MODELS