![background image](http://html1.mh-extra.com/html/winnebago/via-25q/via-25q_manual_987530104.webp)
SECTION 10 –
SLIDEOUT ROOMS
10-6
In the event of a total system failure where
Manual Mode cannot be used, the crank-in
method may be used to retract or extend the
room. See
Slideout Emergency Retraction
elsewhere in this section.
Problems Extending the Room
•
Set the Park Brake if the Engage Park Brake
light flashes while pressing the Extend (OUT)
button.
If an error is detected on your slide system, the
LED light on the control panel will blink an error
code. If an error code appears, see the
manufacturer’s user guide in your InfoCase to
determine the problem. The error code must be
cleared prior to operating the room. To clear the
error, perform the following steps (one at a time)
to reset the system:
•
If none of the “Battery Voltage or Circuit
Breaker Problems” troubleshooting
recommendations reset the system, remove
the touchpad from the wall (a screwdriver will
be needed) and press and hold the RESET
button (“Set Stops/Clear Fault”) located on
the back of the touchpad for 5 seconds. The
slideout is now ready to be extended. Press
OUT on the touchpad to extend the room.
•
If touchpad was removed, reinstall to the wall.
•
Take your RV to an authorized service center
for repair.
Further Information
See the slideout room operating guide
included in your InfoCase for further instructions
and troubleshooting information.
SLIDEOUT EMERGENCY
RETRACTION (POWER GEAR
®
)
If the slideout mechanism is malfunctioning
and the room will not retract using the interior
control switch, you may need to access the
motor/gear assembly and manually crank the
room in to the travel position.
See “Accessing the Motor/Gear Assembly”
for location on your model.
Crank-In Mode
1. Disengage the motor brake, which appears as
a flat “square” protrusion on the protective
boot at the end of the motor. Move the brake
lever slightly - about 1/8 turn counter-
clockwise, or to left when facing end of motor
(repeat for motor at other end of room, if
equipped).
2. Disconnect the motor power lead from the
wiring harness (repeat for motor at other end
of room, if equipped).
3. Use a 3/4” socket and ratchet wrench on the
motor gearbox shaft to crank the room in to
the travel position.
NOTE: If equipped with two motor/gearbox
units, crank both sides of the room
alternately and equally to avoid wedging
the room.
If help is available, a second person
(with a duplicate socket and ratchet)
cranking the other end simultaneously
will greatly speed up the process.
• Light will flash fault
code if system
malfunctions
• Light will flash if
park brake not set
• Low Voltage
Indicator
Slideout Touchpad
-Typical View