![background image](http://html1.mh-extra.com/html/winnebago/travato/travato_user-manual_987391059.webp)
7-7
SECTION 7 –
PLUMBING
To clean the shower pump filter
•
Ensure the Shower Drain switch is OFF.
•
Twist the inlet cap (bowl) “counter-
clockwise” to unscrew from the filter
assembly.
•
Remove the bowl and pull the filter screen out
of the bowl.
•
Rinse filter screen out under clean running
water.
•
Place filter screen back into filter housing.
•
Replace inlet cap (bowl) by twisting
“clockwise”.
Shower Valve Pressure Bleed-Off
After using the shower, you may notice water
dripping from either the shower head or the
faucet assembly. The dripping results when
vacuum in the shower hose (after closing the
shower valve) slowly dissipates and allows water
remaining in the hose to drain down. This is
normal water pressure bleed-off function of the
shower valve assembly and is not a leak or defect.
The International Association of Plumbing
and Mechanical Officials: Standard TSC 21-85
(PAR. 4.3) states:
“Shower heads which incorporate shutoff
valves, shall have a minimum “drip rate” of one
(1) quart in thirty (30) minutes.”
EXTERIOR SHOWER/WASH
STATION
The exterior wash station feature allows you
to do things such as rinse off sand or salt after a
swim, rinse off muddy boots, or bathe your pet
outside the coach. Some models may have a
water pump switch located in the service center
for convenience.
NOTE: The exterior wash station detachable
hose is stored in the rear of the vehicle.
The shower/wash station is not an access point
for potable water, and is not to be used to access
potable water.
Shower Pump
(Located beneath galley cabinet
access panel)
-Typical View
Shower Filter Screen
(Located beneath galley cabinet
access panel)
-Typical View
Exterior Shower/Wash Station
(Typical)