![background image](http://html1.mh-extra.com/html/winnebago/travato/travato_user-manual_987391025.webp)
3-3
SECTION 3 –
DRIVING YOUR MOTORHOME
Lap/Shoulder Belts
See your chassis manual for instructions on
proper fastening, adjustment, and releasing of
lap/shoulder belts.
Seat Belt Care and Cleaning
•
Be careful not to damage the belt webbing and
hardware. Take care not to pinch them in the
seat or doors.
•
Inspect the belts and hardware periodically.
Check for cuts, frays, and loose parts.
Damaged parts should be replaced. Do not
remove or modify the belt system.
•
Keep belts clean and dry. If the belts need
cleaning, use only a mild soap and water
solution. Do not use hot water. Do not use
abrasive cleaners, bleach, or dyes. These
products may weaken the belts.
•
Replace any belt assembly that was used
during a severe impact. Replace the complete
assembly even if damage is not apparent.
CHILD RESTRAINTS
-If Equipped
A properly installed and secured child
restraint system can help reduce the chance or
severity of personal injury to a child in an
accident or during a sudden maneuver. Children
may have a greater chance of being injured in an
accident if they are seated in a child restraint
system which is not properly secured.
A child restraint system is designed to be
secured in a vehicle seat by a lap belt or the lap
belt portion of a lap-shoulder belt.
When purchasing a child restraint system,
follow these guidelines:
1. Look for the label certifying that it meets all
applicable safety standards.
2. Make sure that it will attach to your vehicle
and restrain your child securely and
conveniently so that you are able to install it
correctly each time it is used.
3. Be certain that it is appropriate for the child's
height, weight, and development. The
instructions and/or the regulation label
attached to the restraint typically provides this
information.
4. Review the instructions for installation and
use of the restraint. Be sure that you
understand them fully and can install the
restraint properly and safely in your vehicle.
Tether Anchor Loop
-If Equipped
If your coach has a dinette, it may be equipped
with a child seat tether anchor loop located
beneath the forward facing dinette seat cushion.
1. Lower the dinette table.
NOTE: The dinette table must be in the lowered
position when a child seat is in use.
2. Set child seat upright on dinette seat.
3. Route the tether over the top of the dinette seat
back and hook it to the anchor loop (located
beneath the forward facing dinette seat
cushion). Pull tether strap to tighten.
Tether
Anchor
Loops
-Typical View
NOTE: Your coach may have one or two
tether anchor loops depending on
model.