4-11
SECTION 4
APPLIANCES & SYSTEMS
4 APPLIANCES & SYSTEMS
For LP Gas Operation
Press the Water Heater switch on the Monitor
Panel. The “Pilot Out” light will glow for about
10-15 seconds, then it will go out. The “Heater
On” indicator will remain lit. If the “Pilot Out”
light comes on during LP operation, it means that
the burner has gone into “lockout” mode and
must be restarted. If this happens, turn the Water
Heater switch off for about 5 minutes, then turn it
back on. See the water heater user’s guide in your
Owner InfoCase for further information.
For Quick Recovery Operation
(Dual)
Turn on both Water Heater switches; the gas
one on the monitor panel and the electric one.
This will help reheat the water heater tank more
quickly than a single source would alone. Use
this mode when you are using a larger than nor-
mal volume of hot water.
To Turn Water Heater Off
1. Turn switch on monitor panel to Off position.
2. Turn electric water heater switch off.
3. Turn off LP gas supply (if not to be used for
extended period).
4. Drain water heater tank if the coach is to be
stored or water heater will be Off during
freezing temperatures. (See Draining and
Storage Instructions in
Water Heater
Operation Manual
in your Owner InfoCase.)
PRESSURE- TEMPERATURE
RELIEF VALVE
On occasion, water may be seen seeping from
the water heater pressure temperature relief
valve. This is no cause for repair or replacement
of the valve.
Electric Water Heater Switch
(Typical)
Water Heater Service Access Panel
Water Heater - Exterior Service View
P-T Valve
(Lift Straight Out Slowly -
Let Snap Back)
