SECTION 11
MAINTENANCE/STORAGE
11-8
10. Close all windows and roof vents. Protect all
appliance vent openings from contamination
by animals or insects (e.g. bird nest, wasp
nests, etc.).
11. Lubricate all door hinges and locks.
12. Clean the interior of the coach. Dirt and stains
are more easily removed when fresh.
When storing your vehicle through the winter,
or in cold climates, extra preparations need to be
made to protect systems that can be damaged by
freezing temperatures. See “Winterizing” in
Plumbing Section.
REMOVAL FROM STORAGE
1. Completely air out the motor home.
2. Have the entire LP gas system checked for
leaks.
3. Check window operation.
4. Check cabinet and door hinges. Lubricate
with penetrating oil, if necessary.
5. Close all faucets and drain valves that are
open.
6. Add a few gallons of water to the fresh water
tank and turn on the water pump to check for
leaks especially at fittings.
7. Open all faucets in turn to release trapped air
and check be sure faucet washers have not
hardened during storage.
8. Sanitize the water system as outlined under
“Disinfecting the Fresh Water System” in the
Plumbing Section.
9. After disinfecting and flushing the water lines
thoroughly with fresh water, remove the water
filter diverter plug and install a new water
filter cartridge. Store the diverter for future
use. The diverter plug is intended for
winterization only.
10. Check the toilet for proper operation.
11. Add water to the holding tank using the toilet
flush pedal and galley sink faucet. Check to be
sure dump valves seal tightly.
12. Check around all appliances for obstructions
and ensure that all vent openings are clear.
13. Start refrigerator and check for proper
cooling.
14. Clean paneling and counter surfaces.
15. Replace batteries if necessary and check out
electrical system to make sure all lights and
electrical components operate.
16. Check tires for proper cold inflation pressure.
See Vehicle Certification Label.
17. After washing accumulated winter grime
from the vehicle, it is important to carefully
inspect the seams and sealants for separation
or cracks that may have appeared around the
window frames, vents and any other joints.
See “Sealants” at the beginning of this
section.
Re-sealing is quite simple and the material is
quickly and easily applied. Appropriate
compounds are available from your dealer.
See “Sealants Callout Sheet” at the end of this
section.
Also inspect weather seals around doors, etc.,
and if necessary, have a dealer replace
immediately.
Ice Maker Start-Up
1. Close all drain valves.
2. Turn the water supply on.
3. Be sure the ice bin is in place and the
automatic shutoff arm is down.
4. Let the refrigerator cool down to ice making
temperature. Remember, this can take up to 24
hours.
Let the ice maker cycle and dump the first
batch of ice.
