![background image](http://html1.mh-extra.com/html/winnebago/sightseer-30a/sightseer-30a_operators-manual_987511043.webp)
4-5
SECTION 4 –
APPLIANCES AND SYSTEMS
The approximate fluid levels are measured by
electronic sensors on the sides of the tanks. Tank
levels are displayed as 1/3, 2/3, and Full (F).
There is generally more fluid in a tank than
indicated on the monitor panel.
Tank Capacities
See “Tank Capacities” in
Section 1 -
Introduction
.
Propane Gas Level
Press the Tank Levels switch to show
approximate propane tank level.
The propane level is registered by a sending
unit on the tank. The gauge mounted on the side
of the tank will give a more accurate indication of
actual tank level if needed.
Battery Charge Meter
Press the Battery Levels switch to check the
level of charge (voltage) in the chassis and house
batteries.
To get an accurate reading:
•
Both the chassis engine and the generator
engine must be shut off and 120-volt AC
shoreline unplugged.
•
An interior light should be turned on to
provide a small load which draws off the
battery surface charge.
Water Heater Switches
See Water Heater information elsewhere in
this section for operating instructions.
Water Pump Switch
When use of the self-contained water system
is desired, press the Pump switch (press once to
get to the desired screen, and a second time to
activate or deactivate.) Water will be available as
soon as a faucet is opened.
Tank Levels Switch
Water Tank
-Typical View
Sensors
Battery Levels Switch
LP Gas
Water Heater
Switch
Electric
Water Heater
Switch