SECTION 10 –
SLIDEOUT ROOMS
10-6
cleared prior to operating the room. To clear the
error, perform the following steps (one at a time)
to reset the system:
•
If none of the “Battery Voltage or Circuit
Breaker Problems” troubleshooting
recommendations reset the system, remove
the touchpad from the wall (a screwdriver will
be needed) and press and hold the RESET
button (“Set Stops/Clear Fault”) located on
the back of the touchpad for 5 seconds. The
slideout is now ready to be extended. Press
OUT on the touchpad to extend the room.
•
If touchpad was removed, reinstall to the wall.
•
Take your RV to an authorized service center
for repair.
Further Information
See the slideout room operating guide
included in your InfoCase for further instructions
and troubleshooting information.
SLIDEOUT EMERGENCY
RETRACTION
Crank-In Mode
If the room will not retract using the interior
switch(es) and the mechanism is apparently
malfunctioning, you may need to manually crank
the room in to the travel position.
•
Use a ratchet wrench and a 3/4” socket on the
motor gearshaft to manually crank the room
inward.
•
Your coach is equipped with one or two
motor/gear assemblies. The motor is
accessible through either the exterior
compartment door openings or inside
underneath the galley or bed, depending on
model.
•
Before manually cranking the room inward,
you must disengage the electric brake by
pressing the lever located on the back side of
the motor/gear assembly cylinder as shown in
the following photo.
•
For dual mechanisms, you will need to
alternate between motor/gear assemblies at
each end to move the room in or out.
•
The most effective way for one person to
retract a dual mechanism room is to “walk”
the room in – that is, to crank one side until it
is just slightly ahead of the other, then crank
the opposite side in until it is slightly ahead of
the previous one. Crank both sides alternately
and equally to avoid wedging the room (
see
following Notice
).
Electric Brake Lever
(Located on back side of motor/gear
assembly cylinder)
-Typical View
Motor/Gear Assembly
(Viewed from inside
compartment door opening)
-Typical View
Use 3/4” socket with ratchet on shaft of gear
assembly to crank room inward
