7-9
SECTION 7 –
PLUMBING
NOTE: If waste pump stalls, check breaker in
the load center. If problem persists,
remove end cap and manually turn pump
shaft (located on the end of the waste
pump) with a screwdriver.
Waste Pump Access
Further Information
For further information and operating
cautions, see the waste pump operating
instructions included in your InfoCase.
Dumping Holding Tanks
1. Remove sewage drain hose from water
service center.
2. Remove dust cap from sewage drain outlet
and connect sewer hose. Be sure it is firmly
attached.
3. Place the outlet end of sewer hose into
disposal opening.
4. Open the black water drain valve with a quick
pull and make sure there are no sags in the
hose. Move the hose gently about to dislodge
any waste and ensure complete drainage.
Close black water valve as soon as tank is
empty.
Waste Pump
(Located behind removable panel in
water service center)
-Typical View
Waste Pump Access
(Located behind removable panel in
water service center)
Manual Pump
Access
Sewage Drain
Hose
-Typical View
Sewage Drain Outlet
(Located in driver side compartment)
-Typical View
Dust Cap