SECTION 4 –
APPLIANCES AND SYSTEMS
4-6
Refer to
Section 7 - Plumbing
for additional
information on the water pump and initial start-
up.
NOTE: Some models may be equipped with a
Water Pump switch in the water service
center on the outside of the coach or
within the bathroom area for your
convenience.
WATER HEATER - GAS/
ELECTRIC - MODELS 25T &
25Q
The Gas/Electric Water Heater has a dual
power feature. It can operate from propane gas or
120-volt house current, or it can use both at the
same time for quicker recovery at times when
you are using a lot of hot water.
See the Water Heater manufacturer’s
operation manual provided in your InfoCase for
complete operating instructions, safety
warnings, and maintenance information before
operating the Water Heater.
Be sure the Water Heater is filled with
water before starting either electric or
propane gas operation.
To fill the Water Heater,
turn the Water Pump switch ON and open a hot
water faucet anywhere in the coach. When water
begins to flow steadily from the faucet, the Water
Heater is full.
For Propane Gas Operation
Press the Water Heater LP switch to ON. The
monitor panel display will indicate that the heater
is “On”. If the monitor panel display reads
“Water Heat LP Fail”, it means that the burner
has gone into “lockout” mode and must be
restarted. If this happens, turn the Water Heater
LP switch off for about 5 minutes, then turn it
back on.
For Electric Operation
Press the Water Heater Electric switch to ON.
The shoreline must be connected or generator
running for electric operation.
For Quick Recovery Operation
(Dual Heating)
Turn ON both Water Heater switches -
propane gas and electric. This will help reheat the
Water Heater tank more quickly than a single
source would alone. Use this mode when you are
using a larger than normal volume of hot water.
Water Pump Switch
Propane Gas Water Heater Switch
(Located on OnePlace
®
monitor panel)
Electric Water Heater Switch
(Located on OnePlace monitor panel)
