SECTION 4 –
APPLIANCES AND SYSTEMS
4-12
Heating
To Start Up
6. Open the LP gas tank valve by turning fully
counter-clockwise.
7. Select the desired zone. (Zone 1 or Zone 2)
8. Press the Mode button and toggle between
settings to select either “FURNACE” - (for
Propane Furnace) or “HEATPMP” (for Heat
Pump).
NOTE: The Zone 2 furnace is not equipped on
model 34T and 36G.
The Heat Pump is for Zone 1 only.
9. Adjust the temperature by pressing the +/-
buttons.
10. The furnace fan should start after setting the
thermostat.
11. After approximately 30 seconds, the furnace
burner should light.
12. The furnace should now cycle off and on
automatically as the thermostat demands just
like a household furnace.
NOTE: If heat does not come out of the heat
ducts after a minute or so, the burner is
not lit.
Turn the thermostat off for 3-5 minutes,
ensure Propane Gas Tank valve is open
and tank is not empty, then repeat above
steps.
If the furnace will not light after three
attempts, go to “Shut Down” steps and
contact your dealer or a local RV service
center for repair.
To Shut Down
1. Press the MODE button and select “OFF”.
Repeat steps for each zone.
2. Close the propane tank valve if the
motorhome will be stored for a period of time.
NOTE: If the furnace burner has any residuals
of metal protectant or lubricants used
during manufacture of the furnace, it
may smoke slightly when the furnace is
used for the first time and may set off
your smoke alarm.
We recommend that you provide
adequate ventilation when using the
furnace for the first time to avoid a
nuisance smoke alarm.
We do not recommend removing the
smoke alarm battery.
Cooling (A/C)
1. Select the desired zone.
2. Press the MODE button and select “COOL”:
3. Press the FAN SPEED button to select the
desired speed:
Thermostat “Climate” Screen
(Located on Multiplex Monitor Panel)
• Zone
Button
• Mode
Button
Thermostat “Climate” Screen
(Located on Multiplex Monitor Panel)
• Zone
Button
• Mode
Button
