![background image](http://html1.mh-extra.com/html/winnebago/adventurer-27n/adventurer-27n_manual_987464054.webp)
SECTION 4 -
APPLIANCES AND SYSTEMS
4-12
At the touch of a button, this panel will display
the fresh water and holding tank levels and the
house battery condition. You can start the
generator or turn on the water pump and water
heater. Indicator lights tell you if the water pump
is on or if the water heater pilot light is out.
Water And Holding Tank Levels
Press and Hold the FRESH, BLACK, or
GRAY switch to show approximate level on the
monitor lights.
The approximate fluid levels are measured by
sensors on the sides of the tanks. There is
generally more fluid in a tank than indicated on
the monitor panel.
For example, if the fluid level is 1-2” below
the FULL sensor, the monitor will show the level
to be only 2/3 even though the tank is nearly full.
If a tank is about 1/4 full, the monitor will
register an empty tank because the fluid level is
below the 1/3 sensor even though there is still
fluid in the tank.
However, when the indicator reads FULL, the
tank is actually full.
Black and Gray Waste Level
Selector Switches
(Models 35F only)
This model has two black water tanks - one in
the front, and the other in the rear. Because the
monitor panel can display only one black water
tank level at a time, a selector switch is provided.
Press the Black Waste Level Selector switch
to select the desired black tank level (front or
rear) to be displayed on the monitor panel.
Tank Capacities
See “Tank Capacities” in
Section 1 -
Introduction
.
Propane Gas Level
Press and Hold the LPG switch to show
approximate propane tank level on the monitor
lights.
The propane level is registered by a sending
unit on the tank. The gauge mounted on the side
of the tank will give a more accurate indication of
actual tank level if needed.
Battery Charge Meter
Press and Hold the BATT switch to check the
level of charge (voltage) in the 12-volt house
battery.
Black Waste Level Selector Switch
(Located near monitor panel)