![background image](http://html1.mh-extra.com/html/winnebago/adventurer-27n/adventurer-27n_manual_987464046.webp)
SECTION 4 -
APPLIANCES AND SYSTEMS
4-4
Basic Refrigerator Operation
Temperature controls are factory preset for
your convenience. When you first use your
refrigerator, make sure the controls are still set to
the recommended setting as shown.
See the manufacturer’s user guide provided in
your InfoCase for information on adjusting
refrigerator/freezer temperatures to best suit your
needs.
NOTE: Allow 24 hours for your refrigerator to
cool completely before storing food.
Ice Maker Operation
•
To turn the ice maker on, lower the wire shut-
off arm.
NOTE: Do not force the wire shut-off arm up or
down.
•
To manually turn the ice maker off, lift the
wire shut-off arm to the OFF (arm up) position
until it clicks.
NOTE: Your ice maker is equipped with an
automatic shutoff. As ice cubes fill the
storage bin, the wire arm is raised to the
OFF (arm up position).
Further Information
Refer to the manufacturer’s user guide
provided in your InfoCase for complete operating
instructions, safety precautions, and maintenance
information.
ICE MAKER
–If Equipped
Some refrigerators are equipped with an
automatic ice maker system. The ice maker unit
is installed in the freezer compartment of the
refrigerator.
NOTE: A water shut-off valve for the ice maker
is located near the water faucet filter
inside the galley cabinet beneath the
sink.
Further Information
See the refrigerator manufacturer’s operation,
care and maintenance information in your
InfoCase.
REFRIGERATOR SERVICE
ACCESS COMPARTMENT
(Exterior)
–If Equipped
The exterior refrigerator service compartment
allows access to the rear of the refrigerator for
inspection, maintenance, and service.
To Open
1. Use a screwdriver or coin to turn the latch
knobs to the vertical position as shown.
2. Remove the door from the opening.
To Close
1. Replace the door into the opening.
2. Push the latch knobs in while turning to the
horizontal position as shown.
(Latch shown in unlock position)
-Typical View
Recommended setting is “Mid-setting 3”