![background image](http://html1.mh-extra.com/html/winnebago/2014-sightseer/2014-sightseer_operators-manual_987455052.webp)
SECTION 4 –
APPLIANCES AND SYSTEMS
4-10
Further Information
Refer to the manufacturer’s user guide
provided in your InfoCase for important
information on how this system operates under
several conditions, whether 20-amp, 30-amp, and
50-amp connections, or generator service.
NOTE: In 50-amp service, the load meter is
blank. In all other conditions, the load
meter displays actual current load.
PROPANE GAS FURNACE
To Start Up
1. Open the Propane Gas Tank valve by turning
fully “counter-clockwise”.
2. Slide the Thermostat switch from Off to Heat
and press the Temp Selector button (up/down
arrows) until the desired temperature is shown
on the display.
3. The furnace fan should start to blow
immediately after setting the thermostat.
4. After approximately 30 seconds, the furnace
burner should light.
5. The furnace should now cycle off and on
automatically as the thermostat demands just
like a household furnace.
NOTE: If heat does not come out of the heat
ducts after a minute or so, the burner is
not lit.
Turn the thermostat off for 3-5 minutes,
ensure Propane Gas Tank valve is open
and tank is not empty, then repeat Steps
2-4.
If the furnace will not light after three
attempts, go to “Shut Down” steps and
contact your dealer or a local RV service
center for repair.
To Shut Down
1. Slide Thermostat switch to the Off position.
2. Close propane tank valve if coach will be
stored for a period of time.
Further Information
Refer to the manufacturer’s user guide
provided in your InfoCase for further
information, including operating precautions,
and periodic maintenance. See “Coach
Maintenance Chart” in S
ection 11 - Maintenance
and Storage
for recommended intervals.
NOTE: If the furnace burner has any residuals
of metal protectant or lubricants used
during manufacture of the furnace, it
may smoke slightly when the furnace is
used for the first time and may set off
your smoke alarm.
We recommend that you provide
adequate ventilation when using the
furnace for the first time to avoid a
nuisance smoke alarm.
We do not recommend removing the
smoke alarm battery.
PCS Display Panel
(Located near monitor panel)
-Typical View
Temp Selector
• Press up or
down to select
temperature
Thermostat Switch
• Move to Heat or Gas
position for furnace
operation
-Typical View